Küppersbusch IKE237012T User Manual download pdf (Page 23)

5. Switch on the appliance.

6. Set the temperature regulator to obtain

the maximum coldness and run the ap-

pliance for two or three hours using this

setting.

7. Reload the previously removed food in-

to the compartment.

Warning! Never use sharp metal tools

to scrape off frost from the evaporator

as you could damage it. Do not use a

mechanical device or any artificial

means to speed up the thawing

process other than those

recommended by the manufacturer. A

temperature rise of the frozen food

packs, during defrosting, may shorten

their safe storage life.

WHAT TO DO IF…

Warning! Before troubleshooting,

disconnect the mains plug from the

mains socket.

Only a qualified electrician or compe-

tent person must do the troubleshoot-

ing that is not in this manual.

Important! There are some sounds during

normal use (compressor, refrigerant

circulation).

Problem Possible cause Solution

The appliance does not

operate. The lamp does

not operate.

The appliance is switched off. Switch on the appliance.

The mains plug is not connected

to the mains socket correctly.

Connect the mains plug to the

mains socket correctly.

The appliance has no power.

There is no voltage in the mains

socket.

Connect a different electrical ap-

pliance to the mains socket.

Contact a qualified electrician.

The lamp does not work. The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the lamp".

The compressor oper-

ates continually.

The temperature is not set cor-

rectly.

Set a higher temperature.

The door is not closed correctly. Refer to "Closing the door".

The door has been opened too

frequently.

Do not keep the door open longer

than necessary.

The product temperature is too

high.

Let the product temperature de-

crease to room temperature be-

fore storage.

The room temperature is too

high.

Decrease the room temperature.

Water flows on the rear

plate of the refrigerator.

During the automatic defrosting

process, frost defrosts on the

rear plate.

This is correct.

Water flows into the re-

frigerator.

The water outlet is clogged. Clean the water outlet.

Products prevent that water

flows into the water collector.

Make sure that products do not

touch the rear plate.

Water flows on the

ground.

The melting water outlet does

not flow in the evaporative tray

above the compressor.

Attach the melting water outlet to

the evaporative tray.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

Comments to this Manuals

No comments

Küppersbusch IKE237012T User Manual Page 23

Comments to this Manuals

Related products and manuals for Combi-fridges Küppersbusch IKE237012T