Küppersbusch MGV6100 User Manual Page 34

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 33
Fault code and malfunction Possible cause and solution
The programme does not start The appliance door is not closed.
Close the door.
Mains plug is not connected in.
Put in the mains.
The fuse has blown out in the household fuse box.
Replace the fuse.
Delay start is set.
Cancel the delay start to start the programme immediately.
After the check, switch on the appliance. The
programme continues from the point of in-
terruption. If the malfunction shows again,
contact your Service Force Centre.
These data are necessary to help you quickly
and correctly:
•Model (Mod.)
Product number (PNC)
Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The cleaning results are not satisfactory
The dishes are not clean The selected washing programme is not applicable for the type of
load and soil.
The baskets are loaded incorrectly so that water cannot reach all
surfaces.
Spray arms do not turn freely because of incorrect arrangement of
the load.
The filters are dirty or not correctly installed.
The quantity of detergent is too little or missing.
Limescales particles on the
dishes
The salt container is empty.
The water softener is adjusted on a wrong level.
The salt container cap is not closed correctly.
The dishes are wet and dull No rinse aid has been used.
The rinse aid dispenser is empty.
There are streaks, milky spots
or a bluish coating on glasses
and dishes
Decrease the rinse aid dosage.
Dry water drop signs on
glasses and dishes
Increase rinse aid dosage.
The detergent can be the cause.
Technical data
Dimensions Width cm 59,6
Height cm 81,8-87,8
Depth cm 55,5
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating plate
on the inner edge of the dishwasher door.
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Capacity Place settings 12
34
Page view 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Comments to this Manuals

No comments